2. Installation
2.8 PROFIBUS DP Board Installation
Following two board types can be used for the fieldbus I/O option PROFIBUS DP.
- PCU-DPIO
- PCI-DPIO
2.8.1 Board Appearance
Part names and functions of the scanner board are shown in the following figure. For details
of the status display LEDs, refer to the
4.
Troubleshooting
in this manual.
PCU-DPIO
C0 C1 C2
JP1
JP1
0
1
PROFIBUS-DP Port
LED (2)
(Not in use)
RJ45 Connector
(Not in use)
4-pin Terminal
Watchdog Port
(Do not use this port.)
Jumper for Board Address
Status Display LED (2)
PCI-DPIO
C0 C1 C2
JP1
JP1
0
1
Configuration Port
Communication Status LED
Male 9-pin D-Sub
Port for Board Configuration
Status Display LED (2)
Left: Communication Status LED
Right: Physical Error LED
Jumper for Board Address
Female 9-pin D-Sub
PROFIBUS DP Port
4-pin Terminal
Watchdog Port
(Do not use this port.)
Fieldbus I/O Rev.6
41
Summary of Contents for EM07ZS1647F
