Problem Solving
36
Lamp Error
Lamp Failure
Lamp Cover Open
Check the following two points.
• Take out the lamp and check if it is cracked.
If it is not cracked
- Re-fit the lamp and turn on the power.
If the error continues
- Replace the lamp with a new lamp and turn on the power.
If the error continues
- Stop using the projector, disconnect the power cable from the electrical outlet, and contact
your local dealer or the nearest address provided in the
Epson Projector Contact List
.
If it is cracked
- Replace it with a new lamp, or contact your local dealer for further advice. If replacing the lamp
yourself, be careful to avoid pieces of broken glass (you cannot continue projecting until the lamp is replaced).
Check that the lamp cover and the lamp are securely installed.
If the lamp cover or the lamp is not securely installed, the lamp does not switch on.
When using at an altitude of 1500 m or more, set "High Altitude Mode" to "On".
Airflow Error
The filter is clogged with dust or dirt. Clean or replace the air filter.
: Lit
: Flashing:
: Off
Status
Cause
Remedy or Status
Red
Red
Red
Red
Summary of Contents for EMP-260
Page 1: ...1 User s Guide ...