101
Projector Monitoring and Control using a Network
Projector Monitoring and Control using a Network
The settings will then be applied, and the display will
return to the window that appeared in step 2. Click
[
] to close EMP NetworkManager.
If an e-mail message with "EPSON Projector" in the subject line is sent to
the
that have been set as mail notification destinations, the
message is a notification message saying that there is a problem with the
projector.
The following information will be contained in the body of the message.
Line 1 : The name of the projector where the problem has occurred
Line 2 : The IP address that has been set for the projector where the
problem has occurred
Line 3 : Details of the problem
The details of the problem are listed on separate lines. The following table
shows the details that are given in the message for each item.
* A (+) or (–) will be appended to the start of the message.
(+): When a projector problem has occurred
(–) : When a projector problem has been solved
10
TIP
For security purposes it is recommended that you set a password.
Right-click on the projector icon and select "Change password" to
display the Password Setup window.
If setting a password for the first time, you do not need to type
anything into the "Old password" field. Type in a new password that
is up to 16 characters in length. Up to a maximum of 14 characters
can be registered.
Projector
address...
If a Problem Notification is Sent By Mail
Message
*
/Cause
Remedy
Internal error
"Reading the Indicators"
Fan related error
Sensor error
Lamp cover is open
Lamp timer failure
Lamp out
Internal temperature error
High-speed cooling in
progress
Lamp replacement
notification
No-signal
No image signals are being input to the projector.
Check the connection status or check that the
power for the signal source is turned on.
Summary of Contents for EMP 7800
Page 1: ......
