88
Using the Configuration Menu Functions
Using the Configuration Menu Functions
"Advanced2" Menu
Brightness Control
High
Low
:
Video
Audio
Setting
User's Logo
Advanced1
About
Reset All
Projector ID
Network
Reset
Execute
: 1
[Menu]: Exit
[ ]: Enter
[ ]: Select
Effect
Advanced2
COM Port
BNC Sync Termination
:
ON
OFF
:
Set
Set
RS-232C
USB
Auto Setup
ON
OFF
:
Sub-menu
Function
Default
Brightness
Control
This lets you set the lamp brightness to one of two settings.
Select "Low" if the images being projected are too bright
such as when projecting images in a dark room or onto a
small screen.
When "Low" is selected, the brightness of the images is
reduced, but the amount of electricity consumed and noise
produced during projection are reduced and the lamp's
operating life is extended.
High
Projector
ID
Sets the ID number for the projector.
1
Network
Sets the
and
Address when the projector is connected to a
network and the EMP Monitor function or mail notification
function are being used. It also lets you set the IP address
for a computer to use for notification of problems when
using
for network monitoring.
-
COM Port
This can be set to either "RS-232C" or "USB" depending on
the port that is being used for communication with a
computer.
When this setting is changed, turn the power off, and when
the
period has finished, turn the power back on
again. The new setting will be applied after the power is
turned back on.
RS-232C
Auto Setup Selects whether the automatic adjustment function for
automatically optimising images when the input source is
switched to computer analogue images.
ON
BNC Sync
Termination
Sets the termination mode for the [BNC] port. This is used
for image terminal processing.
•ON : Analogue (75
Ω
) termination
•OFF: TTL (Normal signal level output by the computer)
input
This should normally be set to "OFF". If an analogue (75
Ω
) termination such as for a switcher is required, change
the setting to "ON".
OFF
Summary of Contents for EMP 7800
Page 1: ......
