31
Turning the Projector On
Turn on the power to start projecting images.
Connecting the Power Cable
PROCEDURE
Check that the power is turned off for the projector
and all components connected to the projector.
Connect the computer or other video source to the
projector.
Remove the lens cover.
Hold the lens cover by the knob in the middle of the cover and
remove it.
Connect the accessory power cable to the projector.
Check that the power cable connector is facing the same way as
the power inlet on the projector, and then insert the power cable
connector securely into the projector.
Connect the other end of the power cable to an
earthed electrical outlet.
The Power indicator will light orange.
CAUTION
Be sure to read the separate Safety Instructions/World-Wide Warranty
Terms before projecting images.
TIP
When the "Extended" - "Operation" - "Direct Power ON" menu item
is set to "ON", a confirmation buzzer sounds and the projector's
power turns on as soon as the power plug is inserted into the electrical
outlet, and projection then starts.
The power for the equipment that is connected to the projector should
be turned on beforehand.
1
2
3
4
5
Lit orange