11
User’s Guide
Before Using the Remote Control
Inserting the Batteries
The batteries are not already inserted into the remote control at the time the
projector is purchased. You will need to insert the batteries that are
provided with the projector before the remote control can be used.
PROCEDURE
Remove the battery cover.
While pushing down on the rib of the battery cover, slide the
battery cover in the direction of the arrow.
Insert the batteries.
Replace the battery cover.
Slide the battery cover in until the tab clicks into place.
Caution
Be sure to read the Safety Instructions/World-Wide Warranty Terms
before handling the batteries.
1
Rib
2
Check the positions of the (+) and (–) marks inside the battery
holder to ensure that the batteries are inserted the correct way.
Caution
3
TIP
If delays in the responsiveness of the remote control occur or if it does
not operate after it has been used for some time, it probably means
that the batteries are becoming flat. If this happens, replace the
batteries with two new AA alkali batteries.
Summary of Contents for EMP-830
Page 1: ...User s Guide ...
