58
Connexion de réseau
Le projecteur peut être utilisé dans un système de réseau local, une fois qu’une
connexion de réseau a été établie. La connexion peut être établie au moyen de
EasyConfiguration. Des exemples de configuration de réseau sont donnés dans la
section "Exemples de configurations d’une connexion de réseau" du
Guide
d’utilisation EasyMP.net
Quand vous connectez le projecteur sur le réseau à l’aide d’un câble de réseau,
branchez le câble de réseau sur le port réseau du projecteur et établissez une
connexion de réseau en utilisant la fonction EasyConfiguration (
Quand vous connectez le projecteur sur le réseau par l’intermédiaire d’un réseau
local sans fil, insérez la carte réseau sans fil dans la fente pour carte PC du
projecteur (
p.62) et établissez une connexion de réseau en utilisant
EasyConfiguration (
Summary of Contents for EMP-8300
