Making Detailed Adjustments
45
Other Setup Options
■
Keystone
Adjusts the shape of the image, if the left and right sides are not parallel after tilting the
projector up or down at the screen (see page 25).
■
Projection
Inverts the image for overhead projection.
■
Direct Power On
Sets projection to start when the main power switch is turned on, without pressing the
On
button on the remote control or the
Power
button on the projector.
Note:
When direct power on is enabled, power surges that occur after a power outage can
cause the projector to turn on.
■
Video Signal
Leave this setting on
Auto
so the projector can automatically interpret the format, such as
NTSC or PAL (for standard TV formats).
■
Component
Change this setting to match the type of equipment connected to the Component port.
For component video, select
Auto
to let the projector automatically interpret the signal;
or select
YCbCr
or
YPbPr
to manually select your video equipment’s signal.
■
Trigger Out
Turn on this setting if you want the
Trigger out
port to output a 12-volt signal while
the projector is operating. You can use this to raise or lower your projection screen.
Settings > Keystone
Setting
s
> Projection
Settings > Operation> Direct Power On
Setting
s
> Input Signal> Video Signal
Setting
s
> Input Signal> Component
Setting
s
> Operation > Trigger Out
