68
6
Press the
u
or
d
button to select the type of device you’ve connected, then press the
SEL
(Select) button.
(The names in this step correspond to the categories of devices found in the code tables.)
7
Point the remote control at the component, then enter the first three-digit code number from the code
table. (You do not have to press
SEL
or
ENT
to enter the code.) After you enter a three-digit code, look at
the component to see if it has turned off.
Continue to enter code numbers until the component turns off.
8
When the component turns off, save the code number you entered by selecting the
SAVE
option on the
LCD screen.
9
Press the
MAIN
button twice to exit the SETUP menu.
10
Test the Ensemble HD remote control to make sure it has all the functions you need. When you open the
new component’s menu, you should see all the functions needed to operate it. If any commands are
missing, you can copy them from the component’s original remote control. For instructions, see the section
on using advanced remote control features in the
User’s Guide
.
Note
Refer to the manual that came with your component for instructions on using the commands to operate it.
Connecting Another Subwoofer
To increase the bass presence in extra-large rooms, you can connect an additional powered subwoofer to the
system. Set the added subwoofer’s bypass switch to bypass its built-in crossover (if it doesn’t have a bypass
switch, set its crossover frequency to the maximum). Use an RCA-style audio cable and connect it to the
SUB
OUT
port on the back of the Ensemble HD subwoofer:
47
61
82
FREQ
LEVEL
PWR ON MODE
MASTER
POWER
SUB OUT
BASS CONTOUR CONTROL
98
99
Connect additional powered
subwoofer here
Summary of Contents for Ensemble HD
Page 1: ...Installation Guide ...
