82
Note
You have 30 seconds to complete each step. After that, the remote control returns to normal operation.
2
Select the
RF
option. You see this screen:
3
Select the setting you want to adjust:
•
IR/RF
to cause the remote control to emit IR signals only, RF signals only, or IR and RF signals at the
same time. If a component receives IR signals directly from the remote control and from the base
station at the same time, the signals may interfere with each other, so you should set the remote
control to use only RF signals with that component. (You can select the component in step 4.)
•
ID #
to select the receiver ID # of your addressable base station. Select an address other than 0 (zero) to
prevent interference from other RF remote controls in the vicinity.
•
EMITT
to route commands through specific emitters plugged into the base station. (The
ID #
must be
set to a non-zero address to select this option.)
•
BLAST
to turn the base station’s IR blaster on or off. You may want to turn it off if the blaster’s high-
power LED saturates or overpowers the sensors of some AV components. (The
ID #
must be set to a
non-zero address to select this option.)
4
On the next screen, select whether you want the setting to apply to the menu options for all 10 devices
listed on the MAIN menu of the remote control (select
ALL
) or just the ones for a specific device (select
DEVIC
).
If you select
DEVIC
(Device), the next screen lets you select the device you want the setting to apply to.
Select from
DVD
,
CABLE
,
SAT
, etc. (Use the
PAGE
or
button to display all the devices.)
5
On the next screen, finish adjusting the selected setting:
•
For the IR/RF setting, select
IR&RF
,
IR
, or
RF
.
•
For the ID # setting, select
UP
or
DOWN
to change the ID #.
•
For the EMITT setting, select
ALL
to route the signal through all the emitters. Or select
UP
or
DOWN
to change the Line Output number (this refers to the jack where you plugged in the emitter
for a specific component).
•
For the BLAST setting, select
ON
or
OFF
.
6
Select
SAVE
to save your setting.
7
Select
EXIT
to return to the SETUP menu, or press the
MAIN
button twice to return to normal operation.
RF
IR/RF
ID
EMITT
BLAST
EXIT
Summary of Contents for Ensemble HD
