2. Connect the 50-pin end of the cable to either the right or left
SCSI connector of the scanner; then fasten the connector
with the clamps on the sides of the connector.
3. Connect the 25-pin end of the cable to the SCSI port of your
computer. If you are connecting the scanner to a SCSI
device other than the computer, use a cable with 50-pin
connectors on both ends. Then fasten the connector with the
clamps on the sides of the connector.
Note:
The SCSI port of the Macintosh is the larger port with the
diamond shaped
icon
over
it.
4. The connection is now complete. Connect the power cables.
5. Always turn on the scanner first; then start the computer.
Power-on sequence
You must turn on SCSI devices with terminators (the first and
last devices in the daisy chain) before you turn the computer on
so that information can pass through the SCSI port. If you do
not turn on these devices first, the computer may not start up.
2-8
Connecting the Scanner to the Computer
Summary of Contents for ES-600C
