162
Uninstall Your Product Software
Power Cleaning
Resetting Network Settings
You can reset the network settings to their factory defaults.
1.
Turn off your product.
2.
Hold down the
network status button and press the
power button until the
Wi-Fi light and
Wi-Fi Direct light flash alternately. Then release both buttons.
When the
Wi-Fi light and
Wi-Fi Direct light turn off, the Wi-Fi settings are reset.
Parent topic:
Solving Setup Problems
Check these sections if you have problems while setting up your product.
Product Does Not Turn On or Off
Noise After Filling the Ink
Software Installation Problems
Parent topic:
Product Does Not Turn On or Off
If you cannot turn the product on or off, try these solutions:
• If you cannot turn on your product, make sure the power cord is securely connected and hold down
the power button a little longer.
• If you cannot turn off your product, hold down the power button a little longer. If you still cannot turn off
your product, unplug the power cord, plug the power cord back in, then turn your product on and off
again using the power button.
Parent topic:
Noise After Filling the Ink
If you hear noises from your product after filling the ink tanks with ink, check these explanations:
• The first time you fill the tanks with ink, the product must charge its print head. Wait until charging
finishes before you turn off the product, or it may charge improperly and use excess ink the next time
you turn it on. Your product is finished charging the print head when the
power light stops flashing.
Summary of Contents for ET-2400
