Initializing the Ethernet Card
After you install the Ethernet card in a printer or reinstall it in a new
printer, plug in the printer while pressing down the status sheet
button for at least three seconds to initialize the card.
I
status sheet button
Printing a Status Sheet
You can print a status sheet after you finish initializing the card.
Turn on the printer and press the status sheet button. The status
sheet gives you information about the Ethernet card including the
current configuration, serial number, and address of the card. Keep
the status sheet; you need the information to configure the card.
Using the Ethernet Card With NetWare on a WAN
If you use the Ethernet card in a NetWare environment over a WAN
(Wide Area Network) and connect it to a general phone line
(including ISDN), the card may open the dial-up-router and packets
may be sent to the WAN. To avoid this problem and possible phone
fees, mask the vendor code in the dial-up-router as shown below:
Vendor code
For details on how to mask the vendor code, ask your network
administrator or see your NetWare documentation.
2 EPSON Ethernet Card Supplement
Using Macintosh with
Before configuring the Eth
printer driver is installed i
turned on and the Etherne
your Ethernet card
User's
more information.)
The information on
sections:
Cl Installing EPSON Net!
Monitoring the
Configuring the Ether:
Configuring the Ether:
for Macintosh
Note:
If
you are using Macintosh
the card using EPSON Net
workstation or EPSON Nei
workstation. See your Ether
Installing EPSON Net!
To install EPSON Net! for
1.
Turn on your
2. Create a folder for
3. Insert the EPSON Net!
4. Copy the program
Monitoring the Printers on
You can monitor and
your network according tc
