Entering Keyboard Commands
To change the processor speed, enter one of the keyboard
commands shown in the table below.
Keyboard speed setting commands
Key command
Function
Changes the speed to low (simulated 8 MHz)
Changes the speed to high
You must use the
or
key located on the numeric
keypad. When you set the speed to low, you hear a low tone
from the computer’s speaker; when you set it to high, you hear
a high tone. The speed setting remains in effect until you press
the reset button or turn off the computer, or until you change
the setting.
Note
You can use these commands while you are running a
program. However, if that program uses the command for
another function, you cannot use it to change the processor
speed. If this is the case, exit to your operating system
command prompt and try the command or use the EISA
System Utilities to change the speed, as described below.
Using the EISA System Utilities
You can temporarily change the processor speed using the
EISA System Utilities. This method is convenient if your
application program does not recognize the
key
commands to change the processor speed. Follow these steps:
1. Insert the Reference diskette in drive A.
2. Log onto drive A and type
SD.
Press (Enter) at the next two
screens to bring up the Main Menu.
1-12
Using Your Computer
Summary of Contents for ExpressStation
