Check that your software is properly installed and set up for
your printer. (See your software manual.)
Maintaining the Scanner
To keep your scanner operating at its best, you should clean it
periodically. Before cleaning, unplug the power cable.
Clean the outer case with mild detergent diluted in water.
If the glass of the document table gets dirty, clean it with a soft
dry cloth. If the glass is stained with grease or other hard-to-
remove material, use a small amount of glass cleaner on a soft
cloth to remove it. Wipe off any remaining liquid with a dry
cloth.
Be sure that there is no dust on the glass of the document table.
Dust can cause white spots in your scanned image.
c
Caution:
Be careful not to scratch or damage the glass of the
document table, and do not use a hard or abrasive brush
to clean it. A damaged glass surface can decrease the
scanning quality.
Never use alcohol, thinner or corrosive solvent to clean
the scanner. These chemicals can damage the scanner
components as well as the case.
Be careful not to spill liquid into the scanner mechanism
or electronic components. This could permanently damage
the mechanism and circuitry.
Do not spray lubricants inside the scanner.
Never open the scanner case.
R
Ginger Rev.C
A5 size
Chapter 4
97/07/24
Pass 0, DR
Troubleshooting and Maintenance
4-9
