2
Setting up the Scanner
2-9
Setting the SCSI ID number
The scanner's default SCSI ID number is 2.
If you add the scanner to a system in which one of your SCSI
devices already has a SCSI ID of 2, change the ID number to an
unused number using the rotary switch. See the table below as a
guide.
c
Caution:
Do not set the SCSI ID to an ID number that is already assigned
to another device; otherwise the computer, scanner, and other
devices will not operate properly.
ID
Availability
Description
0
Not recommended
Usually used for hard disk
1
Not recommended
Usually used for hard disk
2
Factory setting of the scanner
3
4
5
6
7
May not be available
Usually used for the SCSI board
The SCSI ID rotary switch
is located at the rear of
the scanner.
Summary of Contents for GT-10000+
Page 3: ...ii ...
Page 7: ...vi ...
Page 19: ...1 10 Getting to Know Your Scanner ...
Page 89: ...5 14 Using the Start Button ...
