Epson IR-320 Technical Reference Manual Download

Page: 273 / 340

Rev.C

5-13 BIOS Functions

IR-320

Technical Reference Manual

Power Management Setup Menu

In this menu, set the items related to power management.

Parallel Port
Mode

This setting sets the parallel port mode. The default setting is "Normal".
There are 4 options, "Normal", "EPP", "ECP" and "ECP+EPP". Make the necessary changes in
accordance with the system configuration.
Note that since an 8-byte continuous I/O space is needed when using the "EPP" setting and
"ECP+EPP" setting, the 3BC/IRQ7 setting cannot be used.
In addition, a DMA channel number is required for the DMA transfer when using the "ECP"
setting and "ECP+EPP" setting.
The definitions for each mode are listed below.
Normal: Also called the SPP (Standard Parallel Port), this mode is for one direction only.
EPP:

EPP stands for Enhanced Parallel Port and is an improvement for the Normal mode I/O
throughput. EPP allows for faster data transfer than Normal mode.

ECP:

ECP stands for Extended Capabilities Port, and it is a mode that supports DMA transfer
and Run Length Enhanced. ECP allows for faster data transfer.

EPP Mode
Select

EPP Mode Select sets the type of EPP mode. The default setting is "EPP1.7".
There are 2 options, the EPP1.7 setting and the "EPP1.9 " setting.
Make the necessary changes in accordance with the system configuration.

ECP Mode Use
DMA

Sets the DMA channel number for the "ECP" and "ECP+EPP" setting.
The default setting is "3". There are 2 options, "1" and "3".
Make the necessary changes in accordance with the system configuration.

Table 5-5 Power Management Setup menu

Items

Description

Video Off
Method

Sets the method to turn the monitor off for the Video Off Mode.
The default setting is DPMS.
Change the setting to match the system configuration (type of connected monitor).
The settings are explained below.
Bland Screen:

Use this setting when connecting an earlier version monitor that is

compatible with power management terminals that only have a video off
function.

V/H SYNC+Blank: This stops output of the horizontal sync signal, vertical sync signal, and display

signal from the video controller. Use this setting for monitors in which power
management is enabled when these signals end.

DPMS:

This activates BIOS control in accordance with the Display Power

Management System (DPMS) function of the video controller. The monitor
must be equipped with the DPMS function.

Video Off In
Suspend

Use this setting to turn off the video when entering Suspend Mode.
The default setting is Yes. Always use the default setting.
Yes:

Choose this to stop video output in Suspend Mode.

No:

With this setting video output continues even in Suspend Mode.

Suspend Type

Set the Suspend method of S1(POS) mode.
The default is "PwrOn Suspend".
There are two options; ”PwrOn Suspend” and ”Stop Grant”.

MODEM Use IRQ

Use this setting on a system with a modem when access to the modem (IRQ resource trap) is
treated as a resume event from Suspend Mode or when the power is turned on by a ring signal
(when the Power On by Ring setting is set to Enabled). The default setting is NA.
This setting is the IRQ resource number allocated to the modem (serial port).

Table 5-7 Integrated Peripherals menu (continued)

Items

Description