The Interface Boards
3. Attach the plug end of
of the interface board.
the FG wire onto the FG pin located on top
4. Set the DIP switches on the interface board according to the manual
accompanying it.
FG wire attached
1. Carefully place the interface board next to the printer as shown
below. Use the CG screw to connect the round end of the FG
(frame ground) wire to the main board.
5-46
Using the Printer Options
Summary of Contents for LQ-1010
