1-8
Setting Up the Printer
1. Make sure the power switch on the printer is turned off. It is
off when the
N
side of the switch is pressed down.
2. Check the label on the back of the printer to make sure the
voltage required by the printer matches that of your electrical
outlet.
c
Caution:
If the rated voltage on the printer and your outlet voltage do
not match, contact your dealer for assistance. Do not plug in
the power cord.
3. If the power cord is not attached to the printer, connect it to
the AC inlet on the printer.
4. Plug the power cord into a properly grounded electrical
outlet.
Installing or replacing the ribbon cartridge
Before installing the ribbon cartridge, make sure that the printer
is not plugged into an electrical outlet.
Follow these steps to install or replace the ribbon cartridge:
1. make sure the printer is turned off.
Summary of Contents for LQ-1150 II
