3. Using
the Software
IMU/USB Interface Board
SEIKO EPSON CORPORATION
7
Logger Software User’s Guide (Rev.20181129)
3.2.3
Log Settings
(1) In “Folder”, specify the full path of the log folder. Click the “…” button to the right and select the log
folder in the file selection dialog box.
* Default Log folder in the software is “C:\imu_data\”
* Please select the user accessible folder for the log folder.
(2) In “Delimiter”, specify the delimiter character.
•
Comma: Comma delimiter
•
Tab: Tab delimiter
(3) In “Unit”, specify the data format used when the measurement data are saved.
•
Digit: Raw data
•
Scale: Scale-adjusted data (raw data multiplied by the scale factor)
The unit of output value can be selected from the following.
Gyro
：
the unit of output value “dps” or “rad/s”
Accl
：
the unit of output value “mG” or “m/s
2
”
Attitude
：
the unit of output value “deg” or “rad” * only for G365PDC0, G365PDF0.
(4) In “Comment”, specify the comment recorded in the beginning of the log file.
(5) In “CheckSum”, specify the logging of communication data error checking status.
(6) In “MaximumEntries”, specify the maximum sample entries per CSV “split” log file.
(7) In “MeasureControl”, specify the automatic sampling stop condition.
Set "Enable/disable automatic sampling stop" by "Termination condition" check.
The stop condition is set by time (Time) or sampling number (Count).
* The automatic sampling stop function is automatically disabled once it is executed.
