3. Using
the Software
IMU/USB Interface Board
SEIKO EPSON CORPORATION
4
Logger Software User’s Guide (Rev.20181129)
3.2
Setting
Start the executable file of the Software (ImuLogger.exe). Click the “Setup” tab in the upper part of the window
and click the “Config” button to open the setup window. The setup window has three tabs: one for Serial Port
settings, one for IMU settings, and one for Log settings. Click the “OK” to activate the settings and close the
window.
3.2.1
Serial Port Settings
(1) Configure the “Connect” to control the connection to each IMU. When the IMU is “checked”, the
connection is enabled.
(2) Configure the “Port”. Check the available port number for USB Serial Port (COMx) in the Device
Manager. Baud rate setting is fixed at 460800 baud.
(3)
After changing the Serial Port settings, restart the Software. After restarting, the settings will
become effective.
