82
Notices
■
Allow the lamp to cool for one hour before replacing it.
■
Unplug the projector during lightning storms or when not in use for extended periods.
■
Don’t place the projector or remote control on top of heat-producing equipment.
■
If you use the projector in a country other than where you purchased it, use the correct power cord
for that country.
■
Don’t stand on the projector or place heavy objects on it.
■
Don’t use the projector outside of the required temperature range of 41 to 95 °F (5 to 35 °C).
Doing so may cause an unstable display and could lead to projector damage.
■
Don’t store the projector outside of the required temperature range of 14 to 140 °F (–10 to 60 °C)
or in direct sunlight for long periods of time. Doing so may cause damage to the case.
WARNING:
The cords included with this product contain chemicals, including lead, known to the
State of California to cause birth defects or other reproductive harm.
Wash hands after handling.
(This
notice is provided in accordance with Proposition 65 in Cal. Health & Safety Code § 25249.5 and
following.)
FCC Compliance Statement
For United States Users
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio or television reception. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause interference to radio
and television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
■
Reorient or relocate the receiving antenna.
■
Increase the separation between the equipment and receiver.
■
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
■
Consult the dealer or an experienced radio/TV technician for help.
WARNING
The connection of a non-shielded equipment interface cable to this equipment will invalidate the FCC
Certification of this device and may cause interference levels which exceed the limits established by the
FCC for this equipment. It is the responsibility of the user to obtain and use a shielded equipment
