134
Related tasks
Pairing the 3D Glasses with the Projector
Charging the 3D Glasses
Cleaning the 3D Glasses
Solutions to Panel Alignment Problems
If the panel alignment does not result in a satisfactory picture, try the following solutions:
• Make sure the
Projection
setting matches the installation position.
• Make sure the projection surface is not colored or textured. Project on a white surface with no texture.
• Leave the projector on for 10 to 15 minutes before adjusting the panel alignment.
• The projected image size should be at least 60 inches (152 cm) during panel alignment.
• If the image contains too much magenta, adjust the red and blue panels.
• If the pattern lines look fuzzy or out of focus, adjust the focus before performing the panel alignment.
Parent topic:
Solving Image or Sound Problems
Related references
Related tasks
Focusing the Image Using the Focus Ring
Adjusting the Color Convergence (Panel Alignment)
Solutions to Sound Problems
If there is no sound when you expect it or the volume is too low or high, try the following solutions:
• Adjust the projector's volume settings.
• Press the
A/V Mute
button on the remote control to resume video and audio if they were temporarily
stopped.
• Check your computer or video source to make sure the volume is turned up and the audio output is set
for the correct source.
• Check the audio cable connections between the projector and your video source.
• Make sure any connected audio cables are labeled "No Resistance".
• If you turn the projector on immediately after turning it off, the cooling fans may run at high speed
momentarily and cause an unexpected noise. This is normal.
Summary of Contents for PowerLite Home Cinema 3900
