58
5.
Move the glasses within 10 feet (3 m) of the projector and hold down the
Pairing
button for at least
three seconds.
The status light on the glasses flashes green and red. If pairing is successful, the light turns green
for 10 seconds and then turns off.
Parent topic:
Charging the 3D Glasses
When the status light on the glasses flashes red to indicate a low battery, it is time to charge the glasses.
1.
Connect the smaller end of the charging cable to the port on the bridge of the glasses.
Note:
Make sure you connect the cable in the correct orientation or you may damage the glasses or
cable.
2.
Do one of the following:
• Plug the other end of the charging cable into a powered USB port on a computer or other device.
Summary of Contents for PowerLite Home Cinema 3900
