Extended Menu
68
Operation
Direct Power On
: You can set whether or not (
On
/
Off
) to enable Direct Power On.
Be careful when this item is set to
On
because this unit turns on at the time of power recovery with this unit plugged-in to an outlet.
Sleep Mode
: When set to
On
, this automatically stops projection when no image signal is being input and no operations are carried
out.
Sleep Mode Timer
: When
Sleep Mode
is set to
On
, you can set the time before the projector automatically turns off within a range
of 1 to 30 minutes.
Shutter Button
: Select an operation to be done when the
[Shutter]
button is pressed. When
Electric Shutter
is selected, the
electric shutter opens/closes.
s
When
Blank
is selected, this turns off the video temporarily.
Shutter Timer
: When set to
On
, this turns off the power automatically 120 minutes after the electric shutter is closed.
Shutter Timer
is set to
On
at the time of purchase. (When Shutter Timer and Sleep Mode are set to
On
at the same time, Sleep
Mode has priority.)
High Altitude Mode
: Set to
On
when using the projector above an altitude of 4921 ft (1500 m).
BNC Sync Termination
: Set the termination for the signal from the BNC input port. This should usually be set to
Off
. Set to
On
when analog (75
Ω
) termination such as for switchers is necessary.
Remote Control Type
: You can select
Normal
or
Simple
depending on the type of remote control.
Set this item to
Normal
to use the remote control provided with the projector. When
Simple
is selected, you can use the remote
control provided with other Epson projectors to operate this projector. This is useful if you want to use a remote control that you
are already familiar with to operate the projector.
However, you cannot use the remote control provided with this projector if this is set to
Simple
. Make sure that the setting is
correct because, if the projector is mounted on the ceiling or somewhere hard to reach, changing it back to
Normal
may be
difficult. Additionally, you cannot use the functions that are not equipped with this projector or the remote control which you use.
Beep
: When this is set to
On
, the confirmation buzzer beeps to notify you that the power turns on or off, the electric shutter opens
or closes, or the cooling down is finished.
Standby Mode
You can use the functions that monitor and control the status of the projector over the network even when the projector is in
standby mode if this is set to
Communication On
.
Air Filter Notice
You can set whether or not (
On
/
Off
) to enable the Air Filter Notice. When this is set to
On
and a clog in the air filter is detected, the
message is displayed on the screen.
Sub Menu
Function
Summary of Contents for PowerLite Pro Z8250NL
