Adjusting the Projected Image
164
•
Point Correction
Corrects slight distortion which occurs partially, or adjusts the screen
position in an overlapping area when projecting from multiple
projectors.
s
Quick Corner, H/V-Keystone, Arc Correction, and Point Correction
cannot be performed at the same time. Select the correction method from
Geometric Correction
in the configuration menu. The default setting
for
Geometric Correction
is set to
H/V-Keystone
, so when [
w
/
],
[
v
/
], [
<
/ ], and [
>
/ ] buttons are pressed, H/V-Keystone
correction is carried out.
Because Quick Corner, H/V-Keystone, Arc Correction, and Point
Correction can be carried out while projecting a test pattern, you do not
need to make preparations by connecting a computer or other
equipment.
Quick Corner
Procedure
A
During projection, press the [Menu] button. Select Settings
menu - "Geometric Correction" and then press the [Enter]
button.
s
"Using the Configuration Menu"
Using the Remote Control
Using the Control Panel
Summary of Contents for PowerLite Pro Z8250NL
