Setup & Operation 10. UPS (Uninterruptible Power Supply)
[For users who use the RC420 Controller with UPS]
The RC420 Controller is configured at factory as shown below:
EPSON RC+4.1 or before
(Windows 2000)
EPSON RC+4.2 or after
(Windows XP)
Computer Name
SN***** (Serial No.*) Computer Name
SN***** (Serial No.*)
User Name
Administrator
User Name
EPSON RC User
Password
Not set
Password
epson
* Serial No. (SN*****)
: ***** denotes a five-digit number and it is unique to each Controller.
When the computer name, user name, or password is changed, the UPS will not
automatically shut down the RC420 Controller in the case of a power failure despite its
setting.
After you change the computer name, user name, or password, configure the UPS again
so that it will automatically shut down the RC420 Controller in the case of a power
failure. For details, refer to the section
10.6.3 Setting up the Automatic Shutdown at the
Time of a Power Failure
.
RC420 Rev.9
103
Summary of Contents for RC420
