S1C63656 TECHNICAL MANUAL
EPSON
143
CHAPTER 5: SUMMARY OF NOTES
5.3 Precautions on Mounting
<Oscillation Circuit>
●
Oscillation characteristics change depending on conditions (board pattern, components used, etc.).
In particular, when a ceramic oscillator or crystal oscillator is used, use the oscillator manufacturer's
recommended values for constants such as capacitance and resistance.
●
Disturbances of the oscillation clock due to noise may cause a malfunction. Consider the following
points to prevent this:
(1) Components which are connected to the OSC1, OSC2, OSC3 and
OSC4 terminals, such as oscillators, resistors and capacitors,
should be connected in the shortest line.
(2) As shown in the right hand figure, make a V
SS
pattern as large as
possible at circumscription of the OSC1, OSC2, OSC3 and OSC4
terminals and the components connected to these terminals.
Furthermore, do not use this V
SS
pattern for any purpose other
than the oscillation system.
OSC4
OSC3
V
SS
Sample V
SS
pattern (OSC3)
●
In order to prevent unstable operation of the oscillation circuit due to current leak between OSC1/
OSC3 and V
DD
, please keep enough distance between OSC1/OSC3 and V
DD
or other signals on the
board pattern.
<Reset Circuit>
●
The power-on reset signal which is input to the RESET terminal changes depending on conditions
(power rise time, components used, board pattern, etc.).
Decide the time constant of the capacitor and resistor after enough tests have been completed with the
application product. When using the built-in pull-down resistor of the RESET terminal, take into
consideration dispersion of the resistance for setting the constant.
●
In order to prevent any occurrences of unnecessary resetting caused by noise during operating,
components such as capacitors and resistors should be connected to the RESET terminal in the
shortest line.
<Power Supply Circuit>
●
Sudden power supply variation due to noise may cause malfunction. Consider the following points to
prevent this:
(1) The power supply should be connected to the V
DD
, V
SS
, V
DDA
and V
SSA
terminals with patterns as
short and large as possible.
In particular, the power supply for V
DDA
and V
SSA
affect R/f conversion accuracy.
(2) When connecting between the V
DD
and V
SS
terminals with a bypass capacitor, the terminals
should be connected as short as possible.
V
DD
V
SS
Bypass capacitor connection example
V
DD
V
SS
(3) Components which are connected to the V
D1,
V
OSC
and V
C1
–V
C3
terminals, such as capacitors,
should be connected in the shortest line.
In particular, the V
C1
–V
C3
voltages affect the display quality.
●
Do not connect anything to the V
C1
–V
C3
terminals when the LCD driver is not used.
