APPENDIX
S5U1C17001H USER MANUAL
Seiko Epson Corporation
27
(ICDMINI VER1.0 and VER1.1)
Code No.
Page
Contents
11
Add description
* When used as the ICD for the S1C33 core, follow the instructions in the
documentation provided with the firmware update.
13
Add description
• Downloading the program to Flash can also be performed in this mode.
• SW7 = OPEN
• * For firmware Ver 1.1 and later, ... It is also possible to connect through the
step of
….
Change description
•
(blue) or (green)
14
Add description
• When (gdb) target sim is executed, the software simulator starts up.
Change description
•
(blue) or (green)
15
Add description
• As flash writer at main unit
• This mode is not used when debugging ... production and so on.
• refer to the readme file below.
Change description
• (3) Save the Flash erase/write program ... C17 fwld sample.saf 0 0 0x8000
• Debugger (gdb.exe)
Deletion of item
readme.txt
Delete information
16
Add description
• (2)If you change the DIP switches with power ....
(yellow)
• The DIP switch settings are enabled by pressing the RESET/START switch.
• Supplement:Instead of pressing .... signal to the BRK IN pin (pulled up to 3.3 V).
17
Add description
•
the USB driver must be installed.For installation of the USB driver, see
Section 4.2, “Connecting to the Host Computer.”
•
The same command can be executed by ..... the firmware update.
Change description
•
(1) Connect only S5U1C17001H to the host computer using USB cable.
• (2) Set the DIP switch SW7 of S5U1C17001H … LED4 (Green)
• (4) Enter the commands shown below .... (5) Check the current firmware
version, …. may not start up.
• (5)
(6) Change of step number
• (6)
(7) Change of step number
•
(blue) or (green)
18
Change description
After completing the operation and the LEDs are as follows; .... the firmware
update may have failed for some reason.
19
Change of description
1. The measuring execution … debug mode entry/exit processing (around 40
cycles)
20
Delete information
21
Change of description
• Notes on target system’s interface
• 0 to 5.0V for Ver 1.0 and 0 to 5.5V for Ver 1.1
24, 25
Add Appendix
6
Change of description
* Recommend AC adapters ...
411153602