SC-F2000
Revision C
DISASSEMBLY & ASSEMBLY
Disassembly and Assembly Procedure
173
Confidential
3.4.6.5 BELLOWS ASSY
1.
Remove the FRONT SUB COVER.
2.
Remove the PLATEN.
3.
Move the Table Feed Mechanism to the rear.
4.
Remove the two screws that secure the BELLOWS ASSY.
A) Silver M3x8 Cup S-tite screw: 2 pcs
5.
Move the Table Feed Mechanism to the front.
6.
Remove the two screws, and remove the BELLOWS ASSY.
B) Silver M3x8 Cup S-tite screw: 2 pcs
Figure 3-135. Removing the BELLOWS ASSY
Pay attention to the positioning points (See
).
Pull out the Table Feed Mechanism as far as it goes, and secure
it with the screws in the order of screw B and screw A.
B
B
Positioning point
Table Feed
Mechanism
BELLOWS ASSY
Positioning point
BELLOWS ASSY
A
A
Summary of Contents for SC-F2000 Series
