G
Press
Enter Password
and enter the password.
Note:
❏
Differentiate between uppercase and
lowercase when entering the password.
❏
If the SSID was entered directly, set
Password
to
Available
before entering the
password.
H
When input is finished, press
OK
.
I
Check the settings and then press
Start Setup
.
J
Press
OK
to finish the procedure.
If the connection fails, select
Print Check
Report
to print a network connection check
report. You can check the action to take in the
report.
K
Close the Network Connection Settings screen.
Directly Connecting
Wirelessly (Wi-Fi Direct)
A direct connection with the printer can be
established temporarily when, for example, the printer
is not connected to a network or you do not have
permission to log on to the network.
Wi-Fi Direct is disabled by default. The following
describes the procedure from enabling Wi-Fi Direct to
connecting.
Note:
The printer can connect with up to four smart devices
or computers at the same time. If you want to connect
another device when there are already four devices
connected, disconnect the connection to the printer
from a device that is already connected.
A
Press
on the Home screen.
Note:
The shape and color of the icon differ depending
on the connection status.
U
“Home screen operations” on page 16
B
Press
Wi-Fi Direct
.
When Wi-Fi Direct is already enabled, the
network (SSID), password, number of
connected devices, and so on are displayed. Go
to step 5.
Note:
If a part of the displayed network (SSID) or
device name, and so on cannot be seen because it
is cut off at the right edge of the screen, press the
corresponding item to display the entire setting
value.
C
Press
Start Setup
.
D
Press
Start Setup
.
Wi-Fi Direct is enabled, and the network
(SSID) and password are displayed.
E
Open the Wi-Fi setting screen on the device
you want to connect with the printer, select the
SSID displayed on the screen of the printer, and
enter the password just as it is displayed on the
screen.
F
When a connection is established, press
Close
to finish the procedure.
G
Press
Close
on the screen of the printer to close
the network connection settings screen.
When the printer driver is installed on the connected
device, you can print using the printer driver.
Note:
When you turn off the power of the printer, the
connections with connected devices are all
disconnected. To reconnect after turning the printer
back on, perform the procedure again from step 1.
SC-P8500D Series/SC-T7700D Series User's Guide
Changing the Network Connection Methods
38
