SC-S30600 Series
Revision B
DISASSEMBLY & ASSEMBLY
Disassembly and Assembly Procedure
120
Confidential
3.4.5.2 Damper Kit
1.
2.
Remove the Left Rear Cover.
3.
Remove the Left Upper Cover.
4.
Remove the CR Cover.
5.
Remove the three screws that secure the Damper Kit.
A) Silver M3x10 screw: 3 pcs
6.
Remove the clamp.
7.
Remove the two screws that secure the Ink Path Holder Assy.
B) Silver M3x10 screw: 2 pcs
8.
While lifting the Ink Path Holder Assy, remove the two screws and remove the Ink
Path Joint.
C) Silver M3x10: 2pcs
9.
Remove the two Joint Rubbers from the Ink Path Joint.
10. Lift the Damper Kit and remove it from the CR Unit.
Figure 3-65. Removing the Damper Kit
A D J U S T M E N T
R E Q U I R E D
When replacing/removing this part, refer to
Items and the Order by Repaired Part” (p200)
and make sure to
perform the specified operations including required adjustment.
C A U T I O N
When the Ink Path Joint is removed at the following step, ink may
drip off from the tube. Prepare a waste cloth or the like in advance
and be careful not to contaminate the surroundings.
Before attaching the Joint Rubbers, let them get wet with cleaning
liquid.
Joint Rubbers
A
C
C
A
A
B
B
Ink Path Joint
Ink Path Holder Assy
CR Unit
Clamp
Damper Kit
Summary of Contents for SC-S30600
