Printable area
This section describes the printable areas for the printer.
If the print range settings in application software are
larger than the following printer printable areas,
sections beyond the specified margins are not printed.
Roll Paper
The gray area in the illustration below shows the
printable area.
The arrow in the illustration indicates the direction
that the paper is ejected.
*
In the printer driver
Layout
screen, selecting
Print Banner
sets the top and bottom margins of
the paper to 0 mm.
Margins for roll paper depend on the settings values
for
Top/Bottom Margins
in the menu, as shown in
the table below.
Settings for
Top/Bottom Margins
U
The default setting is
Standard
.
Settings of Top/Bottom
Margins
Margin Values
Standard
A
,
C
= 30 mm
*
B
,
D
= 3 mm
Settings of Top/Bottom
Margins
Margin Values
Top 3 mm/Bottom 3 mm
A
,
C
= 3 mm
B
,
D
= 3 mm
Top 15 mm/Bottom 15 mm
A
,
C
= 15 mm
B
,
D
= 3 mm
Top 45 mm/Bottom 15 mm
A
= 45 mm
C
= 15 mm
B
,
D
= 3 mm
3 mm
A
,
B
,
C
,
D
= 3 mm
5 mm
A
,
B
,
C
,
D
= 5 mm
*
If
Standard
is selected when the following two
conditions are met, then the top and bottom
margins will be 3 mm.
❏
The paper type settings are one of the following
Singleweight Matte, Coated Paper(Generic), Plain
paper, Plain Paper Thin, Plain Paper Thick, Tracing
Paper, Tracing Paper <LowDuty>, Matte Film
❏
The printer driver print targets are one of the
following
CAD/Line Drawing - Black, CAD/Line Drawing -
Color,CAD/Line Drawing - Bi-Level
c
Important:
❏
Printing is distorted when the trailing edge of
the roll paper comes off the core. Make sure
the trailing edge does not come inside the
printing area.
❏
If the print range settings width
is smaller
than the print data width
, then the
sections beyond the printable width
will
not be printed.
SC-T3100x Series User's Guide
Appendix
158
