GX8 Manipulator 2. Specifications
118
GX series Rev.2
2.3 Specifications
For details of each manipulator specifications, refer to
Appendix A: Specifications.
2.4 How to Set the Model
The Manipulator model for your system has been set before shipment from the factory.
It is normally not required to change the model when you receive your system.
CAUTION
■
When you need to change the setting of the Manipulator model, be sure to set the
Manipulator model properly. Improper setting of the Manipulator model may result
in abnormal or no operation of the Manipulator and/or cause safety problems.
If the custom specifications number (MT***) is described on MODEL of the signature label
(S/N label), the Manipulator has custom specifications.
The custom specifications may require a different configuration procedure; check the
custom specifications number (MT***) and contact the supplier of your region when
necessary.
The Manipulator model can be set from software.
Refer to the chapter
Robot Configuration
in the
EPSON RC+ User’s Guide
.
NOTE
Summary of Contents for SCARA GX Series
