Epson SpectroProofer Mounter PXHACM24, Setup Manual

SpectroProofer Mounter
Setup Guide 

Rev. C

0_Bodyindd               A4 size 
4/25   page 22

FCC Compliance Statement for United States Users

This equipment complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may cause 
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired 
operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. 
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment 
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause 
harmful interference to radio or television reception. However, there is no guarantee that interference will not occur in a particular 
installation. If this equipment does cause interference to radio and television reception, which can be determined by turning the 
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures.

Reorient of relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment to an outlet on a circuit different from that to which the receiver is connected
Consult your dealer or an experienced radio/TV technician for help

WARNING

The connection of a non-shielded equipment interface cable to this equipment will invalidate the FCC Certification of this device and may
cause interference levels which exceed the limits established by the FCC for this equipment. It is the responsibility of the user to obtain 
and use a shielded equipment interface cable with this device. If this equipment has more than one interface connector, do not leave 
cables connected to unused interfaces. 
Changes or modifications not expressly approved by the manufacturer could void the user’s authority to operate the equipment.

For Canadian users

This Class B digital apparatus complies with Canadian ICES-003. 
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

❏
❏
❏
❏