Installing and Configuring the Software for Windows
19
Installing and Configuring the
Software for Windows
This chapter explains how to install the software, configure the print server, and
set up a network port for your Windows computer. It also explains how to set up
additional computers to use the printer on a wireless network.
Before you can configure the print server, you need to make sure that your wireless
network card or adapter is installed and ready. If you have an existing network,
you also need to verify that your access point is operating correctly and linked to
your computer. If you need instructions, see the documentation or help files that
came with your equipment.
Then follow the instructions in these sections:
■
Checking your wireless settings to make sure you’re ready
■
Installing the Stylus C84WN software
■
Configuring the print server
■
Setting up a network port
■
Setting up additional computers
Before You Begin
Before you begin to install and configure the software, do the following:
■
Follow the instructions beginning on page 11 to set up the printer, install ink
cartridges, load paper, and connect the print server.
■
If your computer has a wireless network card or adapter, make sure the
wireless mode is set to
Infrastructure
(if you are connecting to the printer
through an access point), or
802.11b Ad Hoc
(if you are connecting without
an access point). For instructions, see the documentation or online help for
your wireless card or adapter.
Note:
Do not
select a pseudo ad hoc or proprietary ad hoc mode.
Summary of Contents for Stylus C84WN
Page 1: ...EPSON Stylus C84WN Setup and Installation ...
Page 10: ...10 Introduction ...
Page 60: ...60 Configuration Settings ...