Configuration Settings
55
Appendix A:
Configuration Settings
The Wireless Configuration screen includes both fields that display information
and fields that allow you to modify print server settings. Since most of the settings
are configured automatically based on your existing network, you don’t need to
change these settings for the typical wireless network. Some settings, such as the
Server Name or Password, you may want to change for convenience or security.
If you contact EPSON for technical support, you need to provide configuration
information such as the serial number and firmware revision.
Following are definitions of the configuration settings:
Server Name
Name that identifies the print server (and its printer) on your wireless network.
The default is
EAI_xxxxxx
(where
xxxxxx
are the last six digits of the
MAC/Ethernet address). Choose any name that makes it easier for you to identify
the printer (for example,
Epson Ink Jet Printer
). You can enter from one to 32
characters in this field.
Serial Number
Unique number that identifies each EpsonNet 802.11b Wireless Print Server that
is produced. This number is set during manufacture and cannot be changed.
Password
Used to restrict access to the Wireless Server Configuration screen. The default
password is null (blank). The maximum number of characters you can use in this
field is 16.
Firmware Revision
Indicates the version of the software embedded in the print server. This field
cannot be changed.
Summary of Contents for Stylus C84WN
Page 1: ...EPSON Stylus C84WN Setup and Installation ...
Page 10: ...10 Introduction ...
Page 60: ...60 Configuration Settings ...