EPSON Stylus Color 400 Service Manual
Rev.A
2-10
2.1.1.2.1 Paper Gap Adjust Mechanism
This mechanism can be set by the users and can prevent various problems related to low image density
or print with any dirt by changing the positions of PG lever according to the paper types.
Table 2-6. Platen Gap Adjust Lever Setting
Paper
Lever position
PG adjustment value
Normal paper,
Coated paper
Front
0 mm
(1.1mm between head and platen)
Envelopes
Rear
0.9mm
(2.0mm between head and platen)
It is a major premise that parallel adjustment is done correctly for the space between head and platen
(PG adjustment value above) which can be changed by platen gap adjustment.
Parallel adjustment should be done when the serviceman mounts the carriage guide shaft on the printer
mechanism during the production process or repair service. In the adjustment, the space between
parallel adjustment lever and gage should be 1.04 mm.
Summary of Contents for Stylus Color 400
