EPSON Stylus Pro 10000/10000CF
Revision A
Disassembly & assembly
Disassembly Flow
120
4.2.1 Removing the Housing
This sections describes the removal procedure for printer housing parts. See below for an
illustration of the housing parts.
Figure 4-3. Housing Part Diagram
4.2.1.1 Panel Unit Removal
1.
Push the clips (Refer to Figure 4-5. ) on both sides of the panel unit and pull slightly
away from the R Side Cover.
Push it toward you.
Figure 4-4. Panel Unit Removal 1/2
Lift it up
Lift it up then turn over.
Figure 4-5.
(Front View)
(Rear View)
Roll Paper Cover
H Top Cover
R Side Cover
Paper Guide L2
Front Cover Paper Set Lever
Panel Unit
IC Holder Cover
Interface Cover
Paper Guide U
Rear Cover
Waste Ink Cover
1
2
Connector
3
Clip
Clips
Summary of Contents for Stylus Pro 10000 Series
