EPSON Stylus Pro 10000/10000CF
Revision B
Adjustment
Adjustment Steps
206
5.2.3.12 Cutter Pressure Adjustment
This adjustment is needed in case of C362DRV board replacement, Carriage unit
replacement, Sub platen unit replacement and Shutter unit. If the paper cutter operation will
not be performed correct, you may adjust it.
<Required tool>
o
Tension Gauge
<Adjustment procedure>
1.
Select the "Check: Adjustment" from the diagnostic mode and push Enter switch, then
release the capping.
2.
Select "Adj.: Cutter" and press Enter switch to enter the cutter pressure adjustment.
3.
Press Enter switch in several times until "Pressure=35%" will be appeared on the LCD.
4.
Move the carriage unit to the center of most right sub platen.
5.
Connect the string between cutter and hook of the tension gauge.
Figure 5-15. Cutter Pressure Adjustment
6.
When "Exec. Adj.?" will be displayed on the LCD, press Enter switch, the cutter will
be move to downward. At the time, measure the cutter pressure.
7.
Pressing Paper feed +/- switches, adjust the pressure to be within 350 and 700gf.
8.
Press Enter switch, the cutter move to upward.
9.
Move the carriage to the center and most left sub platen, repeat from Step 6 to 8.
Figure 5-16. Adjustment positions
Tension Gauge
Cutter solenoid
String
Paper cutter
Sub platens
Summary of Contents for Stylus Pro 10000 Series
