EPSON Stylus Pro 10000/10000CF
Revision B
Operating Principles
Printer Mechanism Components
77
2.2.3 Cleaning device section
Cleaning device department is built to a certain cleaning unit on the right the main frame.
The waste ink from the cleaning device department is sent to the waste ink tank of the lower
right through this three thin tubes and one pipe. (Refer to following figure.)
Figure 2-12. Cleaning device department
The structure of the cleaning unit is shown in the next figure.
Figure 2-13. Cleaning device department expansion
The explanation of the cleaning device department main component is as follows.
o
Pump assembly
By driving the pump through the cap (close), ink suck from the head nozzle. Usually
ink suck, ink early period fill, cleaning etc. are run. The waste ink from the pump is
sent to the waste ink tank through three lane pipes.
o
Head vacuum cleaner
Combining the tension of rubber and felt. Wiping ink and garbage etc. adhered to the
head nozzle face it drops it.
Cleaning unit
Waste ink tank
M
M
Cleaning unit
Waste ink tank
Cap motor
Cap
Print head
Creaner head
Pump
CR
guide
rail
Summary of Contents for Stylus Pro 10000 Series
