-203
Note:
Software usually overrides control panel settings. Use your software to
make settings whenever possible.
Using the Auto Cut setting
When you want the roll paper to be cut automatically after your
print job, use the Auto Cut setting. To make the Auto Cut setting
using the
Paper Source
button on the control panel, see
“Buttons”. To use the printer software, see “Roll Paper Option”
for Windows or “Roll Paper Option” for Macintosh.
Note:
When the printer cuts the paper, first the left part of the paper is cut,
then the right, and finally the center. Never turn off the printer before
the paper is cut completely.
Cutting the roll paper manually
To cut the roll paper when the Auto Cut setting is off, follow the
steps below.
Cutting after the document is printed
1. Make sure the document is printed, then press the
Paper
Source
button repeatedly until the Roll Auto Cut light is on.
2. Press the
Cut/Eject
button. The roll paper is cut.
Cutting the roll paper at other times
1. Press the
Paper Feed
button to position the paper in place
for cutting.
2. Press the
Paper Source
button repeatedly until the Roll Auto
Cut light is on.
3. Press the
Cut/Eject
button. The roll paper is cut.
Summary of Contents for Stylus Pro 10600 - UltraChrome Ink - Stylus Pro 10600 Print Engine
