EPSON Stylus Pro 4400/4450/4800/4880/4880C
Revision C
Disassembly & Assembly
Disassembly Procedures
261
Install "Mount Assy., Plate, Motor, ASF, SP" following the
steps below.
1.
"Combination Gear 12, 22.4" may fall from the "Mount
Assy., Plate, Motor, ASF, SP" when removing it. If this
happens, properly install the gear as shown below.
2.
Install "Mount Assy., Plate, Motor, ASF, SP" in a way that
avoids interference between "Combination Gear 12,
22.4" and "Spur Gear, 18".
Combination Gear 12, 22.4
Spur Gear, 18
Location of Interference
3.
Insert shaft of frame while aligning it with installation
hole of "Mount Assy., Plate, Motor, ASF, SP".
4.
Confirm that "Spur Gear, 19.2" and "Combination Gear
13.6, 28.8" are engaged.
Shaft
Installation Hole
Combination Gear 13.6, 28.8
Spur Gear, 19.2
Gear Engagement
Location
Summary of Contents for Stylus Pro 4800 Portrait Edition
