EPSON Stylus Pro 4400/4450/4800/4880/4880C
Revision C
Disassembly & Assembly
Disassembly Procedures
352
4.2.9.5 PE Sensor
1.
2.
As seen from the printer rear surface, release the two left "Extension
Spring, 8.08"s from hooks on the frame.
3.
Peel off acetate tape securing the FFC.
4.
Remove the screw securing "Holder, Detector, PE".
C.B.S. 3x6:
1 pc.
5.
Slide "Holder, Detector, PE" to the rear side, release the two hooks of the
"Holder, Detector, PE" from the two frame notches and then remove
"Holder, Detector, PE" from the frame.
Figure 4-213. Holder, Detector, PE Removal_1
Figure 4-214. Holder, Detector, PE Removal_2
C A U T I O N
When performing the following step, be careful not to
scratch the FFC with the screwdriver.
Hooks
Extension Spring, 8.08
Extension Spring, 8.08
Acetate Tape
C.B.S. 3x6
Holder, Detector, PE
Summary of Contents for Stylus Pro 4800 Portrait Edition
