EPSON Stylus Pro 4400/4450/4800/4880/4880C
Revision C
Disassembly & Assembly
Disassembly Procedures
359
Harness, Head / Harness, R1 / Harness, R2
Should be routed along the outside of the two "Harness, Head"s and the
"Harness, Head, Intermit" from the " C593_MAIN Board" until they reach
the point where the "Harness, R1" and "Harness, R2" are connected to the
"C593_SUB-C Board", and there, get the "Harness, R1" and "Harness, R2"
through under the two "Harness, Head"s and the "Harness, Head, Intermit".
Figure 4-225. Head FFC / Intermit FFC_1
Secure one end of the sheet to the "Guide, FFC" with two-sided tape.
Figure 4-226. Head FFC / Intermit FFC_2
Should be secured with the parts below.
Clamp:
6 pcs.
Figure 4-227. Head FFC / Intermit FFC_3
Harness, Head /
Harness, Head, Intermit
Connected to C593_SUB-C
Harness, R1 / Harness, R2
Attachment site
Guide, FFC
Clamps
Summary of Contents for Stylus Pro 4800 Portrait Edition
