Epson Stylus
®
Pro GS6000
Pre-installation Checklist
The estimated setup time for the Epson Stylus Pro GS6000 is 2 to 3 hours. Make sure you have six or more people available
to help lift and guide the printer onto its stand. Follow these guidelines:
Space Requirements
The printer, stand, and take-up roller come on a pallet that weighs 781 lb (354 kg), with its dimensions shown below.
Make sure you can move the equipment from your receiving area to the printer’s final location. For example, make sure
it will fit inside an elevator, through doorways, and around corners. Keep the printer horizontal as much as possible.
The amount of space required to use the printer is shown below, but you’ll need a larger space to assemble it. Clear a large
floor space before unpacking. Be sure to leave enough space behind the printer to load ink and media.
Environmental Requirements
The Epson Stylus Pro GS6000 can be installed in any location with a typical air conditioning or air ventilation system.
No special air purification system is required. Avoid placing the printer near a vent that would blow directly on it.
Additional information about ink cartridge safety is provided in the Material Safety Data Sheets online at
www.proimaging.epson.com
.
52 ½ in.
(133 cm)
115 ½ in.
(293 cm)
43 in.
(109 cm)
61 in.
(155 cm)
150 in.
(380 cm)
108 in.
(275 cm)
