Start Here
3
Squeeze the edge guide and slide it to the left.
4
Load paper against the right edge guide and behind the
tab, with the printable side face up.
4 x 6 in.
(10 x 15 cm)
8½ x 11 in.
or A4
Note:
Don’t load the paper sideways; always load it short
edge first.
5
Slide the edge guide over, against the left edge of
the paper.
Read these instructions before using your printer.
1
Unpack
Power cord
USB Cable
Output tray
Caution:
Do not open the ink cartridge package until you are ready to
install the ink. Cartridges are vacuum packed to maintain reliability.
Remove all protective materials.
2
Turn on
1
Connect the power cable.
Caution:
Do not connect to your computer yet.
2
Press the
power button.
3
Install ink cartridges
Caution:
keep ink cartridges out of the reach of children and don’t drink
the ink.
Note:
The ink cartridges included with your product have a lower yield
due to the ink charging process. This process is carried out the first time
the product is turned on and guarantees a better performance.
Do not load paper yet.
1
Open the printer cover.
Caution:
Do not touch the white cable inside the printer.
2
Shake the ink cartridges, then unpack them.
3
Remove only the yellow tape from each cartridge.
Caution:
Don’t remove any other seals from the cartridges.
4
Insert the cartridges in the holder for each color, and press
each cartridge down until it clicks.
5
Close the printer cover.
6
Press the
stop button to charge the ink. Charging takes
about 2 minutes.
Caution:
Don’t turn off the printer while it is charging or you’ll
waste ink.
4
Load paper
1
Open the paper support, then pull up the extension and tilt
it back slightly.
2
Insert the output tray.
Epson Stylus
®
T22
*411843300*
*411843300*
