EPSON
MSDS # T605700
Version 3.53 (USA)
Page 2 of 4
Release Date 11/2007
Ingestion:
May cause upset stomach. See Section 11 for Toxicology
.
4.
First Aid Measures
4.1
Eyes:
Immediately flush with room temperature, low pressure, clean water for at least 15 minutes
.
Seek
medical attention if eye irritation continues.
4.2
Skin:
Wash surface areas with soap and water. Wash soiled clothing before rewearing. Seek medical
attention if irritation continues.
4.3
Inhalation:
Remove subject to ventilated fresh air. Consult physician if necessary.
4.4
Ingestion:
Seek medical attention if stomach continues to be upset.
5.
Fire Fighting Measures
5.1
Flammability:
Flash point is greater than 248 deg. F / 120 deg. C (closed cup in accordance with
ASTM D3278)
5.2
Extinguishing Media:
Dry chemical or carbon dioxide
5.3
Fire Fighting Instructions:
No special fire fighting procedures are required other than breathing apparatus. No
special explosion hazards are known.
6.
Accidental Release Measures
If a spill occurs, use sponges to wipe-up ink, then rinse area with damp cloth. Place waste in closed container for
disposal. Use proper ventilation. Do not dispose of waste to the sewer. No eye or skin protection required during
clean-up. Wash hands with soap and water.
7.
Precautions for Safe Handling and Use
Keep out of reach of children and do not drink ink. Do not store the cartridge in high or freezing temperatures. Keep
cartridge out of direct sunlight. Do not dismantle cartridge. Do not store cartridges with oxidizing agents or
explosives. Make sure cartridge is dry before insertion into printer housing.
8.
Exposure Controls and Personal Protection
8.1
Engineering Controls:
None
required
8.2
Exposure Controls:
None
required
8.3
Personal Protection:
None required when cartridges are used as intended
9.
Physical and Chemical Properties of Ink Formulation
Appearance:
Light
Black
Liquid
Odor:
None
pH:
9.0 – 10.0
Boiling point:
Approximately 212 deg. F / 100 deg. C
Freezing point:
Less than 32 deg. F / 0 deg. C
Melting point:
Less than 32 deg. F / 0 deg. C
Flash point:
Greater than 248 deg. F / 120 deg. C (closed cup, ASTM D3278)
