![background image](http://html.mh-extra.com/html/epson/tm-930ii-series/tm-930ii-series_operators-manual_2418722037.webp)
[Reference]
Printing USA personal checks
1) Paper size:
70
(Min. 68) mm X 152 mm
2) Paper thickness:
0.09 to 0.2 mm
3) Lengthwise printing (on the back)
Paper width is smaller than the specified standard value, so that paper is fed
using one slip roller at the side. Printing within the printable area shown in the
Figure below is possible, but pay attention to the following points.
Printing may easily become crooked due to being fed by only the one roller.
Paper fed per step is calculated as 0.1771 mm.
From the top of the slip to the printing position is 8.7 mm (= A) (calculated
value).
Printable area is 180 dots (360 positions) from the right edge.
To print endorsements on the back in the specified area (within 1.5 inches
from the top) set the check so that there is a 3 mm space at the bottom.
[Units: mm]
(All the numeric values are typical.)
Figure 5-4. Lengthwise Printing
4) Widthwise printing (on the front)
Paper length is smaller than the specified standard value, so pay attention to
the following points.
The paper-end is detected when the paper is fed to the print starting position.
Since the printable area is not calculated correctly, the printing stop function
using the slip detector should be set disabled. (Refer to ESC
c
4.)
31
Summary of Contents for TM-930II Series
