127
Appendix
Printing and Cutting Positions
When the paper removal detector is disabled (no backfeed)
When the paper removal detector is enabled (with backfeed)
When the paper removal detector is enabled, the top margin can be changed by feeding paper backward.
•
Due to slack in or variations of paper, the actual cutting position will differ from the values shown
below. Set the cutting position in consideration of the variations.
•
To prevent paper jams and to ensure print quality, it is recommended to feed the paper at least 1
mm after paper cutting.
•
Printing position and cutting position will change according to the paper type and software
settings. (
"Software Settings" on page 77
•
The values are design center values for the location of the structure and are different from the top
margin values.
Autocut position
Approx. 36.0 mm
Approx.
14.0 mm
Emergency
cutting position
Paper feed direction
Print head position
(Print start position)
Autocut position
Approx. 36.0 mm
Approx.
14.0 mm
Paper feed direction
Center of the print head
Emergency
cutting position
Approx.
4.0 mm
Print start position
